Comparison
Jet pump vs submersible well pump
One sits above ground and pulls water up. The other sits down the well and pushes it. Depth to water usually decides.
Jet pump vs submersible well pump is mostly decided by how far down the water is. A shallow-well jet pump sits above ground and draws water from less than 25 feet down; a deep-well jet reaches 25 to 250 feet with lower pressure and yield. A submersible sits inside the well below the water and pushes water up, and Nebraska Extension calls it the most common pump for deep private wells.
A well professional picks the pump from the depth to groundwater, the pressure needed and the number and flow of fixtures, per Nebraska Extension. Residential well pump explains the full system.
Jet pump vs Submersible: side-by-side table
From Nebraska Extension G2152, EPA’s private well guidance and Clemson Cooperative Extension.
| Factor | Jet pump | Submersible |
|---|---|---|
| Where it sits | Above ground, on or near the well | Inside the well, below water level |
| How it lifts | A venturi creates a partial vacuum that draws water up | Pushes water up the drop pipe |
| Depth to water | Shallow jet: under 25 feet. Deep jet: 25 to 250 feet, wells 3 inches or smaller | Drilled wells, including deep ones |
| Priming | Needs priming; loses prime if the intake leaks | No priming |
| Frost | Needs frost protection | Below ground |
| Service | Reachable at the surface | Must be pulled from the well |
| Pressure and yield | Deep jets give lower pressure and yield than a submersible | Higher |
When a jet pump is the right call
A jet pump fits shallow water, dug or small-diameter wells, and owners who want the pump at the surface.
- Water less than 25 feet down, for a shallow-well jet.
- A well 3 inches or smaller, where a deep-well jet can reach water a submersible cannot fit.
- Easy surface access for service.
When a submersible well pump is the right call
A submersible fits a drilled well with deep water and a household that needs steady pressure.
- Water deeper than a jet can reach well.
- Higher demand: several bathrooms and irrigation.
- A cold site where a surface pump would need heated protection.
Electrical and well work is for licensed pros
Pulling a submersible, opening the well cap and wiring a pump control are jobs for a licensed well contractor or plumber, and some states license well pump work separately. After any work, EPA advises testing well water; your state or local health department can tell you how.
What moves the cost of either
What moves the price of either pump is the well and the work to reach it.
- Depth to water and to the pump setting.
- Pulling the old pump and drop pipe from the well.
- Wiring, controls and the pressure switch.
- Pressure tank condition and size.
- Water testing after the work.
HyrePlumber publishes no prices for this work until it holds enough sourced, dated quotes. See how plumbing is priced, check a bid with the plumbing quote checker, and read how to choose a plumber before you hire.
Sources
- Nebraska Extension, Private Drinking Water Wells: Water Distribution System Components (G2152). Retrieved October 13, 2026.
- US EPA, Learn About Private Water Wells. Retrieved October 13, 2026.
- Clemson Cooperative Extension, Residential Drinking Water Well: Well Components. Retrieved October 13, 2026.
Questions people ask
Is a jet pump or submersible pump better for a well?
How deep can a jet pump draw water?
Why does my jet pump lose prime?
Should I test my well after pump work?
Related
- Well pump replacement What the job involves.
- Well pump repair Diagnosing a failing pump.
- Well pressure tank The tank that pairs with the pump.
- Water usage calculator Your household demand.